Configuring Network Gateways in a Single-Homed Environment

The following steps guide you through the setup of network gateways in a single-homed environment, where only the internal interface is enabled. This configuration is less common than one that is dual-homed.

To configure a network gateway in a single-homed environment

1. In the AMC, navigate to System Configuration > Network Settings.

2. In the Routing section, click Edit.

   The Routing page displays.

   

3. To route traffic to your network gateway, select one of these routing modes:

   • Default gateway—Specify an IP address for the default gateway. Network traffic received by the appliance, but not matching a static route will be sent to this address.

   • No gateway—Network traffic received by the appliance, but not matching a static route is discarded.

4. Click Save.