Wireless Network Manager Administration Guide

Managing Policies > Managing SNMP Policies > Setting the SNMP ID
Table of Contents

Setting the SNMP ID

Each SNMP agent maintains local information to be used in SNMP v3 message exchanges so that the agent receives incoming messages and sends Trap messages to a manager.

The SNMP Engine ID must be defined before SNMP v3 can be enabled.

To set the SNMP ID

  1. Navigate to Network > Devices.
  2. On the far right of the line in the list for the device you want to configure, click the Edit (pencil) icon. The Config SonicWave page is displayed.
  3. Click on the General tab.

  4. In the System section, in the SNMP Engine ID field, enter the SNMP engine ID.

  5. Click OK.