SonicOS 7.0 High Availability Administration Guide
- SonicOS 7.0
- High Availability
- High Availability Status
- Configuring High Availability
- Configuring High Availability in the Cloud Platform
- Set up an Active/Standby High Availability Configuration Using Azure
- Install the Custom Template
- Enable Identity of Both Virtual Machines (HA1 and HA2)
- Role Assignment
- Check the Networking Tab
- Configuring Active NSv Firewall Using the Associated Public IP
- Configuring Standby NSv Firewall Using the Associated Public IP
- Enable the L3 Mode
- Configuring Active NSv Firewall Using the Floating Public IP
- Configuring HA to Active/Standby with L3 HA link
- Adding Additional Floating Public IP
- Set up an Active/Standby High Availability Configuration Using Azure
- Fine Tuning High Availability
- Monitoring High Availability
- Azure Use Cases
- SonicWall Support
Configuring Active NSv Firewall Using the Associated Public IP
Once you are logged in, register the appliance first. After the registration, follow the steps below.
-
Navigate to Network > System > Interfaces. Change the X0 configuration first, and then X1, as shown below. You will lose access after you change X1.
-
Before changing the X1 Interface IP, take a screenshot of the current configuration. The Default Gateway and DNS Server 1 should remain the same and ensure you won’t lose access to the active firewall during the following steps.
-
After the changes, the Interfaces should look similar to the screenshot below:
Was This Article Helpful?
Help us to improve our support portal