SonicOS 7.0 High Availability Administration Guide
- SonicOS 7.0
- High Availability
- High Availability Status
- Configuring High Availability
- Configuring High Availability in the Cloud Platform
- Set up an Active/Standby High Availability Configuration Using Azure
- Install the Custom Template
- Enable Identity of Both Virtual Machines (HA1 and HA2)
- Role Assignment
- Check the Networking Tab
- Configuring Active NSv Firewall Using the Associated Public IP
- Configuring Standby NSv Firewall Using the Associated Public IP
- Enable the L3 Mode
- Configuring Active NSv Firewall Using the Floating Public IP
- Configuring HA to Active/Standby with L3 HA link
- Adding Additional Floating Public IP
- Set up an Active/Standby High Availability Configuration Using Azure
- Fine Tuning High Availability
- Monitoring High Availability
- Azure Use Cases
- SonicWall Support
Configuring Standby NSv Firewall Using the Associated Public IP
You will access the standby firewall for the first time, so you should also register the appliance before proceeding with the rest of the configuration.
-
Navigate to Network > System > Interfaces, and create the HA interface with the custom zone "HA" using the below IP address schema details (SonicWall uses X2 Interface in the customer template).
-
Security Type: Trusted
.
-
-
The IP Address is the ha-HA2-Interface-X2 found on the Networking tab.
Was This Article Helpful?
Help us to improve our support portal