SonicOS 7.0 High Availability Administration Guide
- SonicOS 7.0
- High Availability
- High Availability Status
- Configuring High Availability
- Configuring High Availability in the Cloud Platform
- Set up an Active/Standby High Availability Configuration Using Azure
- Install the Custom Template
- Enable Identity of Both Virtual Machines (HA1 and HA2)
- Role Assignment
- Check the Networking Tab
- Configuring Active NSv Firewall Using the Associated Public IP
- Configuring Standby NSv Firewall Using the Associated Public IP
- Enable the L3 Mode
- Configuring Active NSv Firewall Using the Floating Public IP
- Configuring HA to Active/Standby with L3 HA link
- Adding Additional Floating Public IP
- Set up an Active/Standby High Availability Configuration Using Azure
- Fine Tuning High Availability
- Monitoring High Availability
- Azure Use Cases
- SonicWall Support
IPv6 High Availability Monitoring
For complete information on the SonicOS implementation of IPv6, see IPv6.
IPv6 High Availability (HA) Monitoring is implemented as an extension of HA Monitoring in IPv4. After configuring HA Monitoring for IPv6, both the primary and backup Security Appliances can be managed from the IPv6 monitoring address, and IPv6 Probing is capable of detecting the network status of HA pairs.
For easy configuration of both IP versions, toggle between IPv6 and IPv4 displays in DEVICE | High Availability > Monitoring.
The IPv6 HA Monitoring configuration page is inherited from IPv4, so the configuration procedures are almost identical. Just select IPv6 and refer to About High Availability and IPv6 HA Monitoring Considerations for configuration details.
Was This Article Helpful?
Help us to improve our support portal