Wireless Network Manager Administration Guide
- Wireless Network Manager
- Getting Started with Wireless Network Manager
- Overview
- Using Air Marshal
- Managing Your Network
- Managing Policies
- Policy Hierarchy
- Select an AP Policy
- Select a Switch Policy
- General
- System
- Spanning Tree Protocol
- Link Layer Discovery Protocol
- Voice VLAN
- Quality of Service (QoS)
- Internet Group Management Protocol (IGMP) Snooping
- Dynamic Host Configuration Protocol (DHCP) Snooping
- Dynamic Host Configuration Protocol (DHCP) Relay
- Loopback Detection
- Jumbo Frames
- Multicast Filtering
- 802.1X
- Static Route IPV4
- DoS
- Radius Server
- Mirror Settings
- Address Resolution Protocol
- Static MAC Address Table
- SNMP
- Ports
- Link Aggregation
- VLAN
- Select an SSID
- Select a Security Policy
- AP Policies
- Using Tags to Manage Access Points and SSIDs
- QoS Policies
- Wi-Fi Multimeda (WMM) Profiles
- Managing Switch Policies
- Managing SNMP Policies
- Managing Switch SNMP Policies
- Policy Hierarchy
- Security
- Admin
- SonicWall Support
Quality of Service (QoS)
From here, you can configure the QoS port settings for the Switch. Select a port you wish to set and choose a CoS value from the drop-down box.
To activate QoS
- Navigate to Policies > Policy Hierarchy > Switch Policy.
- Select the System tab and scroll down to the QoS section.
- Enable the toggle bar, QoS Enable.
- Select the Trust Mode. The options are 802.1p, DSCP or both together. Trust mode helps you to enable to trust any CoS packet marking at ingress.
- Select the Scheduling Method. Options are Strict Priority and WRR.
- If you select WRR scheduling method, specify the class of service priority value - COS (the range is from 0 to 7), DSCP (the range is from 0 to 63), WRR (the range is from 0-128).
Was This Article Helpful?
Help us to improve our support portal