VPN Integration with Layer 2 Bridged Mode

When configuring a VPN on an interface that is also configured for Layer 2 Bridged Mode, you must configure an additional route to ensure that incoming VPN traffic properly traverses the appliance.

To configure VPN integration with Layer 2 bridged mode

1. Navigate to POLICY | Rules and Policies > Routing Rules.
2. Click the +Add icon. The Adding Rule dialog displays.
3. Configure the route as follows:
   • Source: ANY
   • Destination: custom-VPN-address-object (This is the address object for the local VPN tunnel IP address range.)
   • Service: ANY
   • Gateway: 0.0.0.0
   • Interface: X0
4. Click OK.