SonicOS 7.1 System

Map Multiple Interface Pairs

You can create VLAN mapping for multiple pairs of interfaces at the same time. These interfaces must form part of an existing Secure Wire Mode pair at the time of the VLAN mapping creation. You can also create mappings for an interface with multiple interfaces, but only the mappings for the current active Wire Mode pair are in use at any given time.

If the paired interface is changed, the message, Cannot change wire-mode pair interface when WireMode VLAN entries exist for the interface, displays.

Example

Multiple interface pairs mapping

In Multiple interface pairs mapping, a mapping exists for X12 to X13 (policy 1) as well as X12 to X15 (policy 2).

As only X12 and X13 (policies 1 and 3) and X14 and X15 (policies 4 and 6) are currently forming a Wire Mode pair, only policies 1, 3, 4, and 6 are active as indicated by the green checkmark in the active column.

The wire-mode pair interfaces cannot change if Wire Mode VLAN entries exist for the interface.

Was This Article Helpful?

Help us to improve our support portal

Techdocs Article Helpful form

  • Hidden
  • Hidden

Techdocs Article NOT Helpful form

  • Still can't find what you're looking for? Try our knowledge base or ask our community for more help.
  • Hidden
  • Hidden