SonicOS 7.1 Access Points
- SonicOS 7.1 Access Points
- About SonicOS
- About Access Points
- Settings
- Synchronize Access Points
- Provisioning Overview
- Creating/Modifying Provisioning Profiles
- Adding/Editing a Provisioning Profile - Getting Started
- General Settings for Provisioning Profiles
- 5GHz/2.4GHz Radio Basic Settings for Provisioning Profiles
- 5GHz/2.4GHz Radio Advanced Settings for Provisioning Profiles
- Sensor Settings for WIDP in Provisioning Profiles
- Mesh Network Settings for Provisioning Profiles
- 3G/4G/LTE WWAN Settings for Provisioning Profiles
- Bluetooth LE Settings for Provisioning Profiles
- Deleting Access Point Profiles
- Product Specific Configuration Notes
- Managing Access Point Objects
- Firmware Management
- Floor Plan View
- Station Status
- Intrusion Detection Services
- Advanced IDP
- Packet Capture
- Virtual Access Points
- RF Monitoring
- RF Analysis
- RF Spectrum
- FairNet
- Wi-Fi Multimedia
- 3G/4G/LTE WWAN
- Bluetooth LE Devices
- Radio Management
- SonicWall Support
Added Access Points
The access points that have been deployed are shown by clicking the Floorplan List in the top right corner of DEVICE | Access Points > Floor Plan View in the information bar. You can close it by clicking on the X in the corner.
Several ways you can add access points to a floor plan
-
Drag-and-drop existing access points to various floor plans.
-
Click +Add New in the center of the Floor Plan View.
-
Click +Create Floorplan in the Information bar at the top of the page.
-
In Floorplan List click the "+" icon on the Floorplans dialog..
You can alos delete access points from the floor plan.
Access points that have already been added to a floor plan appear as devices in the Floorplan List.
Was This Article Helpful?
Help us to improve our support portal