SonicOS 7.0 Access Points
- SonicOS7.0
- About Access Points
- Settings
- Synchronize Access Points
- Provisioning Overview
- Creating/Modifying Provisioning Profiles
- Adding/Editing a Provisioning Profile - Getting Started
- General Settings for Provisioning Profiles
- 5GHz/2.4GHz Radio Basic Settings for Provisioning Profiles
- 5GHz/2.4GHz Radio Advanced Settings for Provisioning Profiles
- Sensor Settings for WIDP in Provisioning Profiles
- Mesh Network Settings for Provisioning Profiles
- 3G/4G/LTE WWAN Settings for Provisioning Profiles
- Bluetooth LE Settings for Provisioning Profiles
- Deleting Access Point Profiles
- Product Specific Configuration Notes
- Managing Access Point Objects
- Firmware Management
- Floor Plan View
- Station Status
- Intrusion Detection Services
- Advanced IDP
- Packet Capture
- Virtual Access Points
- RF Monitoring
- RF Analysis
- RF Spectrum
- FairNet
- Wi-Fi Multimedia
- 3G/4G/LTE WWAN
- Bluetooth LE Devices
- Radio Management
- SonicWall Support
IEEE802.11V Settings
IEEE802.11V settings are only supported on SonicWave products. These settings take no effect when the VAP is bound to an earlier generation SonicPointN/AC. Under IEEE802.11v Settings, select BSS Transition Management to enable the access point to request a voice client to transition to a specific access point when the client sends a query to the access point. This option is not selected by default.
Select WNM Sleep Mode to enable a non-access point station to signal to an access point that is sleeping for a specified time. This option is not selected by default.
Was This Article Helpful?
Help us to improve our support portal