• Secure Mobile Access 100 10.2 for the
• Introduction
• Before You Begin
  • Supported Platforms
  • KVM/QEMU
  • Hardware-Assisted Full Virtualization
  • Paravirtualization
  • Creating a MySonicWall Account
• Installing the SMA 100 for KVM Virtual Appliance
  • Preparing the Linux Server System
  • Obtaining the SMA 100 for KVM Image
  • Downloading the SMA 100 for KVM Virtual Appliance Software
  • Installing SMA 100 for KVM on Proxmox (PVE)
  • Installing SMA 100 for KVM on a Linux System using the Virtual Machine Manager
• Configuring the SMA 100 for KVM Virtual Appliance
  • Connecting to the Command Line Interface
  • Using the Command Line Interface
    • Setup Wizard
    • Reboot
    • Restart SSL VPN Services
    • Logout
    • Save TSR to Flash
    • Display EULA
• Licensing and Registering Your Appliance
  • Registering the SMA 100 for KVM
• Using the 30-day Trial Version
  • Deployment Considerations
  • Registering the 30-day Trial Virtual
  • Converting a Free Trial License to Full
• Upgrading Your Appliance
  • Obtaining the Latest Image Version
  • Exporting a Copy of Your Configuration
  • Uploading a New Image
• SonicWall Support
  • About This Document

Setup Wizard

This option launches a simple wizard to change the basic network settings, starting with the X0 IP Address, X0 subnet mask, default gateway, primary and secondary DNS, and the hostname. The following CLI output illustrates an example where each field is changed:

If a field is not filled out, the prior value is retained, allowing you to change only a single field. After each field has been prompted, the new network settings are shown and a confirmation message is given for the user to review and verify the changes before applying them. The following shows the result when you save the changes:

After saving the changes, press Enter to return to the original display of the System Information and Network Settings. Verify that the changes have taken effect.

If no changes are saved, a message displays. Pressing Enter returns to the initial display of the System Information and Network settings.

When applying settings that change the IP address, there could be a delay of up to five seconds as the interface settings are updated.