• Secure Mobile Access 100 10.2 for the
• Introduction
• Before You Begin
  • Supported Platforms
  • KVM/QEMU
  • Hardware-Assisted Full Virtualization
  • Paravirtualization
  • Creating a MySonicWall Account
• Installing the SMA 100 for KVM Virtual Appliance
  • Preparing the Linux Server System
  • Obtaining the SMA 100 for KVM Image
  • Downloading the SMA 100 for KVM Virtual Appliance Software
  • Installing SMA 100 for KVM on Proxmox (PVE)
  • Installing SMA 100 for KVM on a Linux System using the Virtual Machine Manager
• Configuring the SMA 100 for KVM Virtual Appliance
  • Connecting to the Command Line Interface
  • Using the Command Line Interface
    • Setup Wizard
    • Reboot
    • Restart SSL VPN Services
    • Logout
    • Save TSR to Flash
    • Display EULA
• Licensing and Registering Your Appliance
  • Registering the SMA 100 for KVM
• Using the 30-day Trial Version
  • Deployment Considerations
  • Registering the 30-day Trial Virtual
  • Converting a Free Trial License to Full
• Upgrading Your Appliance
  • Obtaining the Latest Image Version
  • Exporting a Copy of Your Configuration
  • Uploading a New Image
• SonicWall Support
  • About This Document

Uploading a New Image

SMA 100 for KVM Virtual Appliances do not support downgrading an image and using the configuration settings file from a higher version. To downgrade to a previous version of a SMA 100 for KVM image, you must create a new Virtual Machine or load a snapshot taken earlier.

To upload a new SMA 100 for KVM Virtual Appliance image

1. Download the SMA 100 for KVM image file and save it to a location on your local computer.
2. Select Upload New Firmware from the System > Settings page. Browse to the location where you saved the SMA 100 for KVM Virtual Appliance image file, select the file, and click Upload. The upload process can take up to one minute.

3. When the upload is complete, you are ready to reboot your SMA 100 for KVM with the new SMA 100 for KVM Virtual Appliance image. Do one of the following:

   • To reboot the image with current preferences, click the boot icon for New Firmware.
   • To reboot the image with factory default settings, click the boot icon for New Firmware and select the check box to Boot with factory default settings.

Be sure to save a backup of your current configuration settings to your local computer before rebooting the SonicWall SMA 100 for KVM Virtual Appliance with factory default settings, as described in Exporting a Copy of Your Configuration Settings.

4. A warning message dialog displays that reads, “Are you sure you wish to boot this firmware?” Click OK to proceed. After clicking OK, do not power off the device while the image is being uploaded to the hard disk.
5. After successfully uploading the image to your SMA 100 for KVM, the login screen displays. The updated image information displays on the System > Settings page.