Switch 1.3.0 Release Notes
Version 1.2.0.0
July 2022
Compatibility and Installation Notes
The SonicWall Switch 1.2.0.0 release is supported on all SonicWall Switch platforms:
- SWS12-8
- SWS12-8POE
- SWS12-10FPOE
- SWS14-24
- SWS14-24FPOE
- SWS14-48
- SWS14-48FPOE
For information about obtaining the latest Switch firmware and upgrading the firmware image on your SonicWall Switch, see the Switch Getting Started Guide available on the Support portal at Switch Getting Started Guide.
Resolved Issues
| Issue ID | Issue Description |
|---|---|
| SWO-1709 | OpenSSL upgraded to 1.1.1o |
| SWO-1707 | OpenSSL upgraded to remediate CVE-2022-0778 |
| SWO-1706 | SonicWall Switch Post-Authenticated remote code execution CVE-2022-2323 |
Known Issues
| Issue ID | Issue Description |
|---|---|
| SWO-1739 | The Dynamic Mac Address page does not show any entries on the Firewall Managed SwitchUI, but we can see all entries in the switch console and standalone switch UI. |
| SWO-1713 | There is no pop-up message, and the apply button is not greyed out if the limit exceeds the RMON configuration. |
| SWO-1712 | While creating the IPV4 ACE rule for TCP, entering negative and out-of-range values (Range: 0 - 65535) for the Source and Destination Port fields is possible but should not be allowed. |
| SWO-1708 | The new PoE switch model switches like SWS12-8PoE, SWS12-10FPoE, SWS14-24FPoE, and SWS14-48FPOE running Switch image 1.2.0.0 by default and above cannot be downgraded to 1.1.1.0 and below versions. |
| SWO-1553 | The error is displayed when any configuration change is done on a switch port with 802.1X enabled. |
| SWO-1497 | Switch fails to complete 802.1x authentication when using the EAP-TLS protocol. |
Was This Article Helpful?
Help us to improve our support portal