Secure Mobile Access 100 10.2 Deployment Planning Guide

Configuring a Default Route

Refer to the following table to correctly configure your default route for the scenario you selected.

If you are using scenario: Your upstream gateway IP address will be:
A - SMA on a New DMZ The IP address of the DMZ interface you create
B - SMA on an Existing DMZ The existing DMZ interface IP address
C - SMA on the LAN The LAN interface IP address

To configure a default route

  1. Using Secure Mobile Access, navigate to the Network > Routes page.
  2. Enter the upstream gateway device’s IPv4 address in the Default IPv4 Gateway field or the IPv6 address in the Default IPv6 Gateway field.
  3. Select X0 as the interface and click Accept.