• Secure Mobile Access 10.2 for the Series
• Deployment Scenarios Overview
  • Selecting a Deployment Scenario
  • SMA 210/410 and 500v Deployment Scenarios
• Connecting the SMA on a New DMZ
  • Connecting the SMA to the Gateway
  • Allowing a WAN to SMA Connection
  • Allowing an SMA to LAN Connection
• Connecting the SMA on an Existing DMZ
  • Connecting the SMA to the Gateway
  • Allowing WAN to LAN Connection
  • Allowing DMZ to LAN Connection
• Deploying SMA on the LAN
  • Connecting the SMA to the Gateway
  • Configuring SMA to LAN Connectivity
• Additional Configuration
  • Configuring the X0 IP Address
  • Configuring a Default Route
  • Adding a NetExtender Client Route
  • Setting Your NetExtender Address Range
  • Adding a New SMA Custom Zone
• Testing and Troubleshooting Your Remote Connection
  • Verifying a User Connection from the Internet
  • Policy > Access Rules Matrix View
• SonicWall Support
  • About This Document

Connecting the SMA to the Gateway

To connect the SMA using Scenario B

1. Connect one end of an Ethernet cable to your DMZ, either directly to the corresponding port on your existing SonicWall gateway appliance, to a hub, or to a switch on your DMZ.
2. Connect the other end of the Ethernet cable to the X0 port on your SonicWall SMA 210/410 and 500v. The X0 Port LED lights up indicating an active connection.
3. Configure the SMA X0 with an IP address in the DMZ subnet. Refer to Configuring the X0 IP Address for more information.