• Secure Mobile Access 10.2 for the Series
• Deployment Scenarios Overview
  • Selecting a Deployment Scenario
  • SMA 210/410 and 500v Deployment Scenarios
• Connecting the SMA on a New DMZ
  • Connecting the SMA to the Gateway
  • Allowing a WAN to SMA Connection
  • Allowing an SMA to LAN Connection
• Connecting the SMA on an Existing DMZ
  • Connecting the SMA to the Gateway
  • Allowing WAN to LAN Connection
  • Allowing DMZ to LAN Connection
• Deploying SMA on the LAN
  • Connecting the SMA to the Gateway
  • Configuring SMA to LAN Connectivity
• Additional Configuration
  • Configuring the X0 IP Address
  • Configuring a Default Route
  • Adding a NetExtender Client Route
  • Setting Your NetExtender Address Range
  • Adding a New SMA Custom Zone
• Testing and Troubleshooting Your Remote Connection
  • Verifying a User Connection from the Internet
  • Policy > Access Rules Matrix View
• SonicWall Support
  • About This Document

Adding a NetExtender Client Route

NetExtender allows remote clients to have seamless access to resources on your local network.

To configure a NetExtender client route

1. Using Secure Mobile Access, navigate to the Clients > Routes page.

   

2. To force all SMA client traffic to pass through the NetExtender tunnel, select Enabled in the Tunnel All Mode drop-down menu.

3. Click Add Client Route.

   

4. Enter the network address of the trusted network to which you would like to provide access with NetExtender in the Destination Network field. For example, if you are connecting to an existing DMZ on the 10.1.1.0/24 subnet and you want to provide access to your LAN network on the 192.168.168.0/24 subnet, you would enter 192.168.168.0.
5. Enter the subnet mask of the destination network in the Subnet Mask field. Continuing the example, enter 255.255.255.0.
6. Click Submit to finish adding this client route.