Capture Security Appliance Getting Started Guide
- Capture Security Appliance
- Introduction
- Technical Overview
- Deployment Examples
- Prerequisites for CSa Deployment
- High-Level Task List
- Hardware Overview
- Connect and Power On
- Change the Administrator Password
- Initial Setup Using Web Management
- Register and License
- Upgrade the Firmware
- Configure Allowed Devices
- Related Documents for Additional Configuration
- Creating a MySonicWall Account
- SonicWall Support
Upgrade the Firmware
SonicWall recommends running the latest firmware on your Capture Security Appliance. Your appliance must be registered and licensed in MySonicWall before you can update firmware on it.
To update firmware on your CSa
- Log into your CSa as an administrator.
-
Navigate to the System > Firmware Management page.
- Select the desired version from the Target Version drop-down list.
- Click the Click to Upgrade / Downgrade button.
-
In the Warning popup, click OK.
The appliance loads the selected firmware and restarts. This may take a few minutes.
The next step is to configure your Capture Security Appliance to accept files for analysis from your firewalls and other systems. Proceed to Configure Allowed Devices.
Was This Article Helpful?
Help us to improve our support portal