How to show full interface configuration via ssh using Putty.
Description
Use CLI to see the full configuration of a firewall interface using the diag show debug command. IPv6 is omitted here from the cli output as it is not configured.
Resolution
Command Type: diag show debug
Command: diag show debug interface X1
CLI OUTPUT
admin@C000000000> diag show debug interface X1
Interface Name: X1
Interface is Portshield Host: No
WLAN Tunnel Source IfacE: -1
WLAN Tunnel Id: -1
Comment: Default WAN
Link Status: UP Value: 1
Port Status: UP
Link Type: Ether CSMA/CD Value: 6
Link Speed and Mode: 1 Gbps Full Duplex
Link Ability: 0x80000020 =
ENET_FORCE_SPEED +
ENET_SPEED_1G_FULL
Config MAC: 00:0A:00:6A:09:01
Runtime MAC: 00:0A:00:6A:09:01
MacOverride?: No
MTU: 1492
Effective MTU: 1492
User-configured MTU: 1492
Zone: WAN Handle:2 Type:0
[IPv4 Settings]
IP Address: 192.168.0.10
Network: 192.168.0.0
Network Mask: 255.255.255.0
DNS1: 192.168.0.1
DNS2: 8.8.8.8
DNS3: 4.4.4.2
Config MAC: 00:0A:00:6A:09:01
Runtime MAC: 00:0A:00:6A:09:01
macOverride: No
MTU: 1492
Effective MTU: 1492
User-configured MTU: 1492
Fragment non-VPN packets: Yes
Ignore don't frag bit: No
Send ICMP redirect for Frag needed: No
ARP proxy-management PCs: No
Egress Bandwidth Mgt Enabled: No
Kbps available for Egress Bandwidth Mgt: 384
Ingress Bandwidth Mgt Enabled: No
Kbps available for Ingress Bandwidth Mgt: 384
Enable Swflow on Interface: Yes
Enable multicast on Interface: Yes
Send pkts w/802.1 tags if policy allows: Yes
Management Interface: Yes
IfVirtual tag value: 0x00000000
Enable Default 802.1p CoS: No
Default 802.1p CoS value: 0x00000000
Interface http Management: No
Interface https Management: Yes
Interface ssh Management: Yes
Interface ping Management: Yes
Interface snmp Management: No
Interface http User Login: No
Interface https User Login: Yes
Interface http Redirect Rule: Yes
Interface add DHCP Lease: No
Failover Group: 0
Gateway MAC: 0C:02:0B:05:07:65
Gateway IP: 192.168.0.1
dnsServer1: 192.168.0.1
dnsServer2: 8.8.8.8
dnsServer3: 4.4.4.2
WAN Mode: NAT Static IP Value: 2
WAN Mode State: proto_start Value: 0
Use Routed Mode: NO
