• SonicOS 7.0 Capture ATP
• Capture ATP
  • About Capture ATP
    • Files are Preprocessed
    • Files Blocked Until Completely Analyzed
    • Files are Sent over an Encrypted Connection
    • Capture ATP Friendly Filename Display
    • Activating the Capture ATP License
  • Enabling Capture ATP
  • About the Capture ATP Page
    • Basic Setup Checklist
    • Bandwidth Management
    • Exclusions
    • Custom Blocking Behavior
  • Configuring Capture ATP Settings
  • Disabling GAV or Cloud Gateway Anti-Virus
  • Capture ATP Location
• Scanning History
• SonicWall Support
  • About This Document

Basic Setup Checklist

The Basic Setup Checklist:

• Displays the status of Capture ATP and its components, Gateway Anti-Virus and Cloud Gateway Anti-Virus.
• Displays any error states that might be present.
• Allows enabling or disabling of the Capture ATP service.
• Provides links to the POLICY > Security Services > Gateway Anti-Virus page for the GAV, Cloud Gateway Anti-Virus, and protocol inspection settings.
• Displays a matrix of the protocol inspection settings and whether the inbound and outbound directions have been enabled.
• For messages that display in this section, see the Capture ATP Status through Protocols Inspection Settings tables. Enabled corresponds to a green checkmark, and Disabled corresponds to a red X.

The Inspected Protocols table also provides a manage settings link that takes you to the POLICY | Security Services > Gateway Anti-Virus page. There, you can enable or disable inspection of specific network traffic protocols, including HTTP, FTP, IMAP, SMTP, POP, CIFS, and TCP Stream. Each protocol can be managed separately for inbound and outbound traffic.

The table that follows Inspected Protocols displays the current inspection settings for each protocol, in each direction; see Protocols Inspection Settings.