SonicOS 7.1 High Availability Administration Guide
- SonicOS 7.1
- About SonicOS
- High Availability
- High Availability Status
- Configuring High Availability
- Configuring High Availability in the Cloud Platform
- Set up an Active/Standby High Availability Configuration Using Azure
- Install the Custom Template
- Enable Identity of Both Virtual Machines (HA1 and HA2)
- Role Assignment
- Check the Networking Tab
- Configuring Active NSv Firewall Using the Associated Public IP
- Configuring Standby NSv Firewall Using the Associated Public IP
- Enable the L3 Mode
- Configuring Active NSv Firewall Using the Floating Public IP
- Configuring HA to Active/Standby with L3 HA link
- Adding Additional Floating Public IP
- Set up an Active/Standby High Availability Configuration Using Azure
- Fine Tuning High Availability
- Monitoring High Availability
- Azure Use Cases
- SonicWall Support
Monitoring High Availability
On DEVICE | High Availability > Monitoring, you can configure independent management IP addresses for each unit in the HA Pair. You can also configure physical/link monitoring and logical/probe monitoring.
- Configuring Active/Standby High Availability Monitoring
- IPv6 High Availability Monitoring
- IPv6 HA Monitoring Considerations
Was This Article Helpful?
Help us to improve our support portal