SonicOS 7.1 High Availability Administration Guide
- SonicOS 7.1
- About SonicOS
- High Availability
- Replacing an HA Primary Unit
- High Availability Config
- Configuration of HA Active/Standby
- Configuring Active/Standby High Availability Settings
- Configuring HA with Dynamic WAN Interfaces
- Configuring Network DHCP and Interface Settings
- Disabling the SonicOS DHCP Server
- Configuring Virtual IP Addresses
- Configuring Redundant Ports
- Fine Tuning High Availability
- Advanced Settings
- Configuring Advanced High Availability Settings
- Monitoring High Availability
- Configuring Active/Standby High Availability Monitoring
- Configuring Active/Standby High Availability Settings
- IPv6 High Availability Monitoring
- About This Document
- Azure Use Cases
- SonicWall Support
Configuring Standby NSv Firewall Using the Associated Public IP
You will access the standby firewall for the first time, so you should also register the appliance before proceeding with the rest of the configuration.
-
Navigate to Network > System > Interfaces, and create the HA interface with the custom zone "HA" using the below IP address schema details (SonicWall uses X2 Interface in the customer template).
-
Security Type: Trusted
.
-
-
The IP Address is the ha-HA2-Interface-X2 found on the Networking tab.
Was This Article Helpful?
Help us to improve our support portal