SonicOS 7.1 High Availability Administration Guide
- SonicOS 7.1
- About SonicOS
- High Availability
- Replacing an HA Primary Unit
- High Availability Config
- Configuration of HA Active/Standby
- Configuring Active/Standby High Availability Settings
- Configuring HA with Dynamic WAN Interfaces
- Configuring Network DHCP and Interface Settings
- Disabling the SonicOS DHCP Server
- Configuring Virtual IP Addresses
- Configuring Redundant Ports
- Fine Tuning High Availability
- Advanced Settings
- Configuring Advanced High Availability Settings
- Monitoring High Availability
- Configuring Active/Standby High Availability Monitoring
- Configuring Active/Standby High Availability Settings
- IPv6 High Availability Monitoring
- About This Document
- Azure Use Cases
- SonicWall Support
Configuring Active NSv Firewall Using the Floating Public IP
On the Active firewall, Log in using the Floating Public IP address. To get the IP:
- Navigate to Resource Groups.
-
Select the VM ha-HA1.
-
On the left panel, press Networking.
-
Network Interface: ha-HA1-Interface-X1.
-
On the left panel, press IP configurations.
-
Copy and paste the Floating Public IP address into the browser.
Was This Article Helpful?
Help us to improve our support portal