• SonicOS 7
• Introduction
• NSa Series Overview
  • Deployment Options
    • Internet Edge Deployment
    • Medium and Distributed Enterprises
  • NSa Hardware Features
  • NSa System Requirements
• NSsp 10700, 11700, and 13700 Overview
  • Features
    • Connectivity, Port Density and Performance
    • Firmware Features
  • Hardware Features
    • +
    • Rear Panel
    • System Specifications
• Determining the WAN Type
• System Setup
  • Default Settings
  • System Startup
  • Basic Configuration
  • Registration and Licensing
  • Creating a MySonicWall Account
• Setup Options
  • Zero Touch
  • Setting Up with NSM
  • Setting Up with SonicExpress
  • Setting Up with CLI
• Running the Setup Wizard
• Testing and Troubleshooting Connectivity
• Migration Tool
  • About Migration
  • Using the Migration Tool
• SonicWall Support
  • About This Document

System Startup

Once the firewall is connected to a power source, SonicOS comes up within a few minutes. You can configure the firewall from either the X0 or MGMT interface. The X0 interface can be configured as a static, transparent, or Layer-2, Bridged-Mode interface. The MGMT port is a dedicated 1 Gigabit Ethernet interface for appliance management and SafeMode access.

To configure HTTPS management via X0

1. Connect your management computer to the X0 interface. DHCP addressing is available by default on X0.
2. In your browser, enter the default IP address https://192.168.168.168 and log in using the default credentials:

   Username: admin

   Password: password

3. Your default password must be changed at first time while logging in after upgrade. Create a password that meets the security requirements. A password should have at least one uppercase letter, one lowercase letter, one number, and one special character. For example, S0nicW@ll.

   

4. Perform the following steps to change password:
   1. In Old Password text box, enter your default password.
   2. In New Password text box, enter your new password.
   3. In Confirm Password text box, re-enter your new password.
5. Click Change Password.
6. Refer to Basic Configuration for the remaining steps for a basic configuration.

To configure HTTPS management through the MGMT port

1. Connect your management computer to the MGMT interface.
2. Configure your computer with a static IP address on the 192.168.1.0/24 subnet, such as 192.168.1.20.
3. In your browser, enter the default IP address https://192.168.1.254 and log in using the default credentials:

   Username: admin

   Password: password

4. After Enter your default user name and password. Your default password must be changed at first time while logging in after upgrade. Create a password that meets the security requirements. A password should have at least one uppercase letter, one lowercase letter, one number, and one special character. For example, S0nicW@ll.

   

5. Perform the following steps to change password:
   1. In Old Password text box, enter your default password.
   2. In New Password text box, enter your new password.
   3. In Confirm Password text box, re-enter your new password.
6. Click Change Password.
7. Refer to Basic Configuration for the remaining steps for a basic configuration.

If the services are enabled while using the MGMT port, you can also access SafeMode, SSH or ping via the MGMT port. From SafeMode, you can upgrade firmware, boot backup images and more.

You can also configure your firewall using the SonicOS command line interface (CLI). For more information on using CLI, refer to Setting Up with CLI.