SonicOS 7.0 Tools & Monitors
Viewing Connections
Your SonicWall network security appliance maintains a connections log for tracking all active connections to the SonicWall network security appliance.
To view the Connections table
- Navigate to Monitor | Tools & Monitors > Connections.
- Click IPv4 or IPv6 to view the connections for that IP type.
The column names for the table are described in the following:
| Src MAC | MAC address of the source device. |
| Src Vendor | Manufacturer of the source device. |
| Src IP | IP address of the source device. |
| Src Port | Port number of the source device. |
| Dst MAC | MAC address of the destination device. |
| Dst Vendor | Manufacturer of the destination device. |
| Dst IP | IP address of the destination device. |
| Dst Port | Port number of the destination device. |
| Protocol | Protocol used for the connection, such as TCP or ICMPv6. |
| Src Iface | Interface on the source device. |
| Dst Iface | Interface on the destination device. |
| Flow Type | Flow type of the connection, such as generic or HTTP Management. |
| IPS Category | Type of Intrusion Prevention System (IPS) used; N/A = Not Available. |
| Expiry (sec) | Number of seconds remaining before the connection expires. |
| Tx Bytes | Number of bytes transferred. |
| Rx Bytes | Number of bytes received. |
| Tx Pkts | Number of packets transferred. |
| Rx Pkts | Number of packets received. |
| Flush | Contains the Flush icon for each entry. |
Was This Article Helpful?
Help us to improve our support portal