• Secure Mobile Access 10.2.1.2WireGuard
• Document Scope
• WireGuard
  • Configuring WireGuard
  • Connecting WireGuard on NetExtender
  • Configuring WireGuard
• SonicWall Support
  • About This Document

Configuring WireGuard

WireGuard can be configured on the Services > Settings page in the SonicWall Secure Mobile Access web-based management interface.

To enable WireGuard connector:

1. Go to Settings page under Services tab to view the various setting options.

2. In the VPN Tunnel Type Setting section select the VPN Tunnel Type as WireGuard.

   

   Wireguard can be connected on the client only if it is enabled in the management interface. Else, it will be connected to SSLVPN.

   You can make WireGuard as your first preference while connecting it on the client by moving it to the top, using the arrow symbol.

3. In the WireGuard Service Settings section enter the WireGuard Port and Keepalive Interval information.

   

   The configured port must be opened in firewall for UDP protocol.

4. Click Accept to save the setting.