Basic Setup Checklist

The Basic Setup Checklist:

• Displays the status of Capture ATP and its components, Gateway Anti-Virus and Cloud Gateway Anti-Virus.
• Displays any error states that might be present.
• Allows enabling or disabling of the Capture ATP service.
• Provides links to the POLICY > Security Services > Gateway Anti-Virus page for the GAV, Cloud Gateway Anti-Virus, and protocol inspection settings.
• Displays a matrix of the protocol inspection settings and whether the inbound and outbound directions have been enabled.
• For messages that display in this section, see the Capture ATP Status through Protocols Inspection Settings tables. Enabled corresponds to a green checkmark, and Disabled corresponds to a red X.

Capture ATP Status

Icon	Message	Link	Action
Enabled	Capture ATP service is enabled until renewal_date.	disable it	Click the link to turn off Capture ATP and put the service in disabled mode. You do not need to click Accept to apply this change.
Disabled	Capture ATP subscription is valid until renewal_date but the service is not currently enabled.	enable it	Click the link to turn on Capture ATP and put the service in enabled mode. You do not need to click Accept to apply this change.
Disabled	Capture ATP subscription expired on renewal_date.	renew it	Click the link to go to MySonicWall to renew the service.

Gateway Anti-Virus Status

Icon	Message	Link	Action
Enabled	Gateway Anti-Virus is Enabled.	manage settings	Click the link to display the POLICY | Security Services > Gateway Anti-Virus page.
Disabled	You must enable Gateway Anti-Virus for Capture ATP to function.	manage settings	Click the link to display the POLICY | Security Services > Gateway Anti-Virus page.

Cloud Gateway Anti-Virus Database Status

Icon	Message	Link	Action
Enabled	Cloud Gateway Anti-Virus Database is enabled.	manage settings	Click the link to display the POLICY | Security Services > Gateway Anti-Virus page.
Disabled	You must enable the Cloud Gateway Anti-Virus Database for Capture ATP to function.	manage settings	Click the link to display the POLICY | Security Services > Gateway Anti-Virus page.

The Inspected Protocols table also provides a manage settings link that takes you to the POLICY | Security Services > Gateway Anti-Virus page. There, you can enable or disable inspection of specific network traffic protocols, including HTTP, FTP, IMAP, SMTP, POP, CIFS, and TCP Stream. Each protocol can be managed separately for inbound and outbound traffic.

The table that follows Inspected Protocols displays the current inspection settings for each protocol, in each direction; see Protocols Inspection Settings.

Protocols Inspection Settings

Icon	Message
Enabled	Protocol is inspected.
Disabled	Protocol is not inspected.
n/a	Inspection is not applicable to this protocol in this direction.