After creating device profiles, assign them to the local users. Device profiles can be Allow profiles and Deny profiles. Allow profiles identify attributes of the client’s network that must be present before a user is authenticated, and Deny profiles identify attributes of the network that cannot be present. If multiple profiles are defined for a user, connection to the SMA appliance is granted only when a client’s environment fulfills all Allow profiles for the user and does not fulfill any Deny profiles. Use the EPC page on the Users > Local Users > Edit page to assign device profiles to a user.
NetExtender login can be disabled on platforms where EPC is enabled.
To configure device profiles to be used when authenticating a local user
When the Edit Local User page appears, go to the EPC Settings section. Use the EPC Settings page to enable or disable EPC for the user, select how to handle authentication requests from unsupported clients, and to add or remove device profiles.
Fields in the Specify how often EPC checks should be done on client systems section vary, depending on whether you are configuring EPC for the Global group or a local user. To configure EPC for the Global group, select Check at login to do EPC checks only when users login, or select Check Periodically to also do EPC checks at set intervals. For example, to do EPC checks whenever a user logs in and every x minutes thereafter while the user is logged in, select Check Periodically, and type the number of minutes to wait between EPC checks.
OR
To configure EPC for a local user, select Use Global Settings or Custom Settings from the Recurring EPC drop-down menu. If you select Use Global Settings, the local user inherits the EPC settings from the Global group. If you select Custom Settings, the Check at login and Check Periodically prompts are displayed and you can configure EPC, as explained for the Global group.
Either select Inherit global device profiles to use all defined Allow and Deny device profiles for the user.
OR
Add or remove profiles using the Edit EPC page: