Linksys WRT54GS

The SMA appliance should be configured on the LAN switch of the Linksys wireless router. This guide assumes that your Linksys is assigned a single WAN IP, through DHCP by the cable ISP and is using the default LAN IP address scheme of 192.168.1.0/24.

Version 2.07.1 firmware or newer is recommended for this setup.

To configure your Linksys for operation with the SMA appliance, you must forward the SSL (443) port to the IP address of the SMA appliance

1. Log in to the Linksys device.

2. Navigate to the Applications & Gaming tab.

   

3. Enter the following information:

   Information to be added to Applications & Gaming Tab

   Application	SMA	The name for the port forwarded application.
   Port Range Start	443	The starting port number used by the application.
   Port Range End	443	The ending port number used by the application.
   Protocol	TCP	The SMA application uses TCP.
   IP Address	192.168.1.10	The IP address assigned to the SMA appliance.
   Enable	Checked	Select the check box to enable the SSL port forwarding.

4. With the configuration complete, click Save Settings at the bottom of the page.

   The Linksys is now ready for operations with the SMA appliance.