Switch 1.1 Release Notes
Version 1.1.0.0
June 2021
Compatibility and Installation Notes
The SonicWall Switch 1.1 release is supported on all SonicWall Switch platforms:
- SWS12-8
- SWS12-8POE
- SWS12-10FPOE
- SWS14-24
- SWS14-24FPOE
- SWS14-48
- SWS14-48FPOE
For information about obtaining the latest Switch firmware and upgrading the firmware image on your SonicWall Switch, see the Switch Getting Started Guide available on the Support portal at: Switch Getting Started Guide.
What's New
- Support for Switch management by Wireless Network Manager 3.5.
Resolved Issues
Issue ID | Issue Description |
---|---|
SWO-1493 | Static route additions and modifications on Standalone Switch management interface leads to logging out from Switch management interface. |
SWO-1445 |
Users are not able to create MAC ACE on Standalone Switch management interface for VLAN ID, 802.1p and Ether Type when value selected is "Any". |
SWO-1444 |
IPv4 ACE Protocols like ICMP, IPinIP, EGP, IGP, HMP, RDP, IPv6, OSPF, PIM, L2TP shows source and destination port input fields on Standalone Switch management interface. |
SWO-1383 |
SSH protocol uses 3des-cbc to log into the Switch by default. Provided option to change the default cipher on Switch. |
SWO-1267 |
Users are not able to create MAC based ACE with user defined EtherType Value. |
SWO-1169 |
Segmentation fault observed while creating MAC/IPv4 ACE/ACL continuously using automation scripts and SWS goes into reboot loop. |
SWO-467 |
Switch interface can be untagged to only one VLAN at a time. |
Known Issues
Issue ID | Issue Description |
---|---|
SWO-1574 | Jumbo Frames are not working as expected when speed and duplex is set to 100Mbps/Full. |
SWO-1569 | SonicWall Switch fails to dynamically update the Switch host or Switch network ARP entries in ARP table. |
SWO-1568 | Unable to edit/delete static route on Standalone Switch management interface when next hop address is not reachable from the Switch |
SWO-1553 | When any configuration change is done on a Switch port with 802.1X enabled, error is displayed. |
SWO-1497 |
Switch fails to complete 802.1x authentication when using with EAP-TLS protocol. Workaround: We can use PEAP, CHAP. |
SWO-1486 |
User unable to create VLAN from standalone Switch management interface. Workaround: Remove the interface which needs to be part of new VLAN from VLAN 1 before creating a new VLAN. |
SWO-1452 | SNMP related settings are not available on Switch. |
SWO-1443 |
Users are not able to differentiate mandatory and non-mandatory field while creating MAC or IPv4 based ACE's on Standalone Switch management interface. |
SWO-1274 | User able to create IPv4 ACE with Invalid IP subnet_mask from standalone Switch management interface. |
SWO-1094 |
Switch console shows errors and gets stuck in some scenarios. Workaround: Power cycle the Switch. |
SWO-764 | Unable to download/export Switch logs from Standalone Switch management interface. |
SWO-466 | Switch interfaces should be a part of VLAN1 or any other VLAN configured. |
Was This Article Helpful?
Help us to improve our support portal