• Secure Mobile Access on Hyper-V 12.4
• Introducing SMA 8200v for Hyper-V
  • Supported Platforms
  • Hardware Resource Requirements
  • Files for Installation
• Setting Up SMA 8200v on Hyper-V
  • Installing the SMA 8200v on Hyper-V
  • Completing Hyper-V Setup
• Configuring Settings in AMC
• Licensing and Registering Your SMA 8200v
  • Creating a MySonicWall Account
  • Retrieving Your SMA 8200v License
  • Importing Your SMA 8200v License
  • Registering the SMA 8200v
  • License Manager
• Upgrading the 8200v Virtual Appliance
• SonicWall Support
  • About This Document

Completing Hyper-V Setup

This section is only applicable if you used ISO file for deploying Hyper-V.

If you used VHD file for deploying Hyper-V, the Hyper-V setup starts automatically and the virtual machine boots from the hard drive and you can configure the SMA 8200v from the console.

1. To start the virtual machine, right-click it and select Start. It boots from the DVD.

   

   After a successful start, an SMA 8200v is created and the virtual machine is automatically stopped.

2. Remove the ISO DVD, as it is no longer needed. (Under Media, select None.)

   

3. Change the virtual machine BIOS boot order so that the hard drive comes before the CD.

   

4. Connect the network adapters to the appropriate virtual switch in the Hyper-V environment.

   

   The next time the virtual machine is started, it boots from the hard drive and you can configure the SMA 8200v from the console.