• Secure Mobile Access 10.2 for the SMA 100 Series
• Deployment Scenarios Overview
  • Selecting a Deployment Scenario
  • SMA 210/410 and 500v Deployment Scenarios
• Connecting the SMA on a New DMZ
  • Connecting the SMA to the Gateway
  • Allowing a WAN to SMA Connection
  • Allowing an SMA to LAN Connection
• Connecting the SMA on an Existing DMZ
  • Connecting the SMA to the Gateway
  • Allowing WAN to DMZ Connection
  • Allowing DMZ to LAN Connection
• Deploying SMA on the LAN
  • Connecting the SMA to the Gateway
  • Configuring SMA to LAN Connectivity
• Additional Configuration
  • Configuring the X0 IP Address
  • Configuring a Default Route
  • Adding a NetExtender Client Route
  • Setting Your NetExtender Address Range
  • Adding a New SMA Custom Zone
• Testing and Troubleshooting Your Remote Connection
  • Verifying a User Connection from the Internet
  • Policy > Access Rules Matrix View
• SonicWall Support
  • About This Document

Policy > Access Rules Matrix View

If the SMA zone does not appear in the POLICY | Rules and Policies > Access Rules matrix view, verify that it is selected as the zone for the gateway interface connected to the SMA appliance.

To ensure the SMA zone displays in the matrix view

1. Using SonicOS, navigate to the NETWORK | System > Interfaces page.
2. Click the Configure icon for X2 or the port you assigned as the SMA zone.
3. Select SMA as the Zone from the drop-down menu.
4. Click OK.