• Secure Mobile Access 10.2 for the SMA 100 Series
• Deployment Scenarios Overview
  • Selecting a Deployment Scenario
  • SMA 210/410 and 500v Deployment Scenarios
• Connecting the SMA on a New DMZ
  • Connecting the SMA to the Gateway
  • Allowing a WAN to SMA Connection
  • Allowing an SMA to LAN Connection
• Connecting the SMA on an Existing DMZ
  • Connecting the SMA to the Gateway
  • Allowing WAN to DMZ Connection
  • Allowing DMZ to LAN Connection
• Deploying SMA on the LAN
  • Connecting the SMA to the Gateway
  • Configuring SMA to LAN Connectivity
• Additional Configuration
  • Configuring the X0 IP Address
  • Configuring a Default Route
  • Adding a NetExtender Client Route
  • Setting Your NetExtender Address Range
  • Adding a New SMA Custom Zone
• Testing and Troubleshooting Your Remote Connection
  • Verifying a User Connection from the Internet
  • Policy > Access Rules Matrix View
• SonicWall Support
  • About This Document

Configuring a Default Route

Refer to the following table to correctly configure your default route for the scenario you selected.

To configure a default route

1. Using Secure Mobile Access, navigate to the Network > Routes page.
2. Enter the upstream gateway device’s IPv4 address in the Default IPv4 Gateway field or the IPv6 address in the Default IPv6 Gateway field.

3. Select X0 as the interface and click Accept.